0.1- 2000MHz RF Broadband Amplifier Low Noise LNA Gain 30dB

Description

0.1-2000MHz RF Broadband Amplifier Low Noise LNA Gain 30dB
Applications:
The amplifier has a wide frequency range, high gain, low noise figure, etc., can be used for a variety of RF receiver front, increase the communication distance! Wide range of shortwave, FM radio, remote control receiver, cable TV signal amplifier, etc. need low noise small signal radio frequency amplification place! The amplifier is sold by default bare board.
Technical indicators
Operating frequency: 0.1-2000MHz
Amplifier gain: as shown below
F = 0.1 MHz, gain = 32 dB
F = 500Mhz gain = 31dB
F = 1000MHz gain = 29dB
F = 1500Mhz gain = 25dB
F = 2000 MHz gain = 20 dB
Maximum output power: + 10dBm (10mW) @ 1dB compression point
Supply voltage: 6 - 12VDC
System impedance: 50 ohms
The use of this amplifier skills:
1 device in the operating frequency is less than 600MHz, with a very good gain flatness, after careful adjustment can be less than 1dB. The lower the frequency the higher the consistency of the gain.
2) The lower operating frequency of the amplifier is controlled by the input and output capacitors, the default is 0.1uF, can work to 0.1MHz; if you need a lower frequency of the amplifier can contact the owner.
3) When the supply voltage in the 5-8V change, can be used as variable gain amplifier, power supply voltage increase gain. Very suitable for RF receiver front-end circuit, with the CPU to control the supply voltage DA, to achieve automatic gain control
4) When the supply voltage in the 8-10V, low-frequency side gain of 30dB, this time the amplifier has a low noise figure and better stability.
5) When the voltage is 12V, the gain reaches the maximum value, the low frequency side gain is up to 32.5dB,
Quantity: 1pcs