-40%
5-3500MHz 20dB with Shield RF Broadband Low Noise Signal Amplifier Module 3.3-6V
$ 3.84
- Description
- Size Guide
Description
HomeArduino
Module
Sensor
Chips
About Us
Description:
5-3500MHz RF Broadband Signal Amplifier Power Amp High Gain 20dB with ShieldingFeatures
This amplifier has a wide frequency range, gain stability, low noise figure, dynamic range + 20dBm @ 1dBP), etc. Advantage, especially for a variety of RF receiver front-end circuit, increase the communication distance! Widely used in shortwave, FM radio, remote control receiver, cable TV signal amplifier, Beidou, GPS satellite navigation, 2.4G Bluetooth, WIFI receiver RF front end need low noise small signal radio frequency amplification place.
Specifications:
Operating frequency: 5-3500MHz
Amplification gain: 20dB (typical)
Noise figure: 1.3 (typical)
Maximum output power: + 20dBm (100mW) @ 1dB compression point
Operating current: 80mA (5V)
Supply voltage: 3.3-6VDC
System impedance: 50Ω
Size: 5.2x2.4cm/2.05x0.94"
Packing Included:
1PCx5-3500MHz RF Power Amplifier
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
Fill your shipping info
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.