-40%
Farmall IH International Char Lynn power steering end cap assembly # 382951r1
$ 173.71
- Description
- Size Guide
Description
One, new, complete, remanufactured, power steering hand pump, control end cap assembly for Farmall 504, 2504 or International Harvester 404, 2404 tractors if you have the four port power IH steering unit (torque generator) that was supplied by Char Lynn. This end cap assembly comes complete with ALL NEW housing, needle bearing, O-rings, retainers and seals as shown in the parts manual. The bearing is already pressed in to the new aluminum cap and the seals are already worked into their grooves. This end cap fits the hydraulic power steering unit (torque generator) 382924r91 and is the end right under the steering wheel that you see sticking up through the dash. This is the aluminum end cap that you are likely to break when you are changing out a rusted on steering wheel. All you need to do on this unit is take your old control end cap assembly off and save the steering stub shaft. Then, reassemble the shaft into the new cap using the new retainers and rings that are also furnished. It is just that easy. All the pre-assembly work has been done and all parts match Char Lynn Specs in exact detail. This end cap will NOT fit the 2 port PS unit on these same models. Check your parts manual if you have questions or concerns. This is a great new item and is ready to go back on your failed unit. IH part number for this complete assembly is 382951r1. The 9 items in this assembly are;382951 r1 end cap -new
382954 r91 bearing -new
355965 r1 o-ring -new
382418 r1 o-ring -new
382957 r1 retainer -new
382953 r1 ring x 2 -new
382781 r1 o-ring -new
382958 r1 ring -
new
As you may already know, this end cap assembly and all of it's associated internal parts are no longer available from CNH or Char Lynn as they were discontinued many years ago. Free domestic shipping to US 48 states. Contact me if you have questions about these torque generators as I have several parts here and I rebuild these units.